Friday, November 6, 2015
How to Reset a Canon Canon MP237 Error P07 and E08
On this occasion we will try sharing again about how to Reset a Canon Canon MP237 Error P07 and E08.
Early Indications:
When the Canon MP237 is switched on, it will immediately appear error P07/E08 on its LCD panel. And if we do, then the print commands on the screen of monitor will perform "The Ink Absorber is Almost Full".
Canon MP237 Error image caption and P07 E08 on the screen monitor as follows (figure illustration):
And how to troubleshoot Canon Canon MP237 Error P07 and E08:
How to Reset a Canon Canon MP237 Error P07 and E08
- Turn on your Printer Canon Canon MP237, then the LED light will blink, and there is a description of "The Ink Absorber is Almost Full" on the screen of your monitor.
- Download Resetter Canon MP237 here.
- Canon printer Canon MP237 should be in SERVICE MODE. Do I read the next step.
- Turn off the MP237 Canon Canon error P07/E08 by pressing the power button. Do not unplug the power cable
- Press and hold the STOP/RESET button followed by pressing the POWER button. So the two buttons depressed position.
- Off button STOP/RESET but don't loose POWER button.
- In the circumstances the POWER button still depressed, press the STOP/RESET button as much as 6 times.
- Then release both buttons at the same time. Then the Canon Canon MP237 will be in a condition of Service Mode.
- The next step of extract and run the Service Tool you download results above 3400.
- In Clear ink absorber counter menu select Play then click the SET on the right.
- Ink absorber counter in menu select Play then click the SET on the right.
- Then click EEOPROM. then the printer will print a 1 page.
- Canon printer Canon MP237 error P07/E08 will be normal again.
Good Luck
